Product Description

mould component water plug based on the water flow directions ,used in plastic mold or colling and heating systems.
  Features :
Based on the water flow directions,any of the cooling and heating systems will have the fitting function in the plastic molds.
How to use it :
1.When installing into molds,please make sure the space is at least 0.1mm widet than cooling circuit plsgs.
2.If there is no specific setting for the cooling circuit plugs :first release,then using the air spray to reset,pressure capacity
Using :
8mm cooling cirsuit plugs for over 16kg/cm2
10mm cooling circuit plugs for over 17kg/cm2
12mm cooling circuit plugs for over 19kg/cm2
Specialty :
1.No tapping,no rust
2.Can be adjusted for tightness
3.Can be placeg at any water path and moved accordingly.
4.Can be cooling down or heating up by water or oil.
5.Under normal operating temperature : -5~120
6.Special operating temperature : -10~250



threeup can manufacture worldwide standard plastic mould component .such as date insert ,air poppet valves,parting locks,slide locks ,slide retainers,roller lock sets,heat pipes,mould counter,taper lock pin,taper block set,straight block set ,locating ring,water plugs,gas vent,submarine gate,ball plungers,sprue bushing,ejector pins,puller bolt,stop pins,lock pins etc.

Payment Terms︰ TT

Product Image